Ambient Weather WS-108 Bedienungsanleitung PDF herunterladen (Seite 43)

Problem

Solution

Move the display console around electrical noise generating devices, such as

computers, TVs and other wireless transmitters or receivers.

Outdoor sensor array

does not communicate

to the display console.

The sensor array may have initiated properly and the data is registered by the

console as invalid, and the console must be reset. The reset button is next

to the LED, near the mounting point on the sensor array, as shown in Figure

11.

With an open ended paperclip, press the reset button for 3 seconds to

completely discharge the voltage.

Take out the batteries and wait one minute, while covering the solar panel

to drain the voltage.

Put batteries back in and resync with console by powering down and up

the console with the sensor array about 10 feet away.

Bring the sensor array inside the house (you can disconnect it from the rest

of the sensors). The LED next to the battery compartment will flash every 16

seconds. If the LED is not flashing every 16 seconds…

Replace the batteries in the outside sensor array. Non-rechargeable batteries

are OK for testing purposes.

If the batteries were recently replaced, check the polarity. If the sensor is

flashing every 48 seconds, proceed to the next step.

There may be a temporary loss of communication due to reception loss

related to interference or other location factors,

or the batteries may have been changed in the sensor array and the console

has not been reset. The solution may be as simple as powering down and

up the console.

Replace the batteries in the outside sensor array. Non-rechargeable batteries

are OK for testing purposes.

With the sensor array and console 10 feet away from each other, remove AC

power from the display console and wait 10 seconds. Re-connect power.

Temperature sensor

reads too high in the

day time.

Make certain that the sensor array is not too close to heat generating sources

or strictures, such as buildings, pavement, walls or air conditioning units.

Use the calibration feature to offset installation issues related to radiant heat

sources. Reference 6.5.

Absolute pressure

does not agree with

official reporting

station

You may be viewing the relative pressure, not the absolute pressure.

Select the absolute pressure. Make sure you properly calibrate the sensor to

an official local weather station. Reference Section 6.5 for details.

Rain gauge reports

rain when it is not

raining

An unstable mounting solution (sway in the mounting pole) may result in the

tipping bucket incorrectly incrementing rainfall. Make sure you have a

stable, level mounting solution.

Sunrise and sunset is

incorrect

Make certain your time zone, longitude and latitude are set properly.

1 2 ... 38 39 40 41 42 43 44 45 46

Kommentare zu diesen Handbüchern

Keine Kommentare

Ambient Weather WS-108 Bedienungsanleitung Seite 43

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Navigationskompasse Ambient Weather WS-108